Subscribe Us

Ethernet bonding in RHEL | CentOs

Bonding (also known as “Ethernet bonding”) is a computer networking arrangement in which two or more network interfaces on a host computer are combined for redundancy or increased throughput.

Modes:
mode=0 (Balance-rr) – This mode provides load balancing and fault tolerance.
mode=1 (active-backup) – This mode provides fault tolerance.
mode=2 (balance-xor) – This mode provides load balancing and fault tolerance.
mode=3 (broadcast) – This mode provides fault tolerance.
mode=4 (802.3ad) – This mode provides load balancing and fault tolerance.
mode=5 (balance-tlb) – Prerequisite: Ethtool support in the base drivers for retrieving the speed of each slave.
mode=6 (Balance-alb) – Prerequisite: Ethtool support in the base drivers for retrieving the speed of each slave.

Note: Always append extra configuration in case of a rollback.

1.Configuring  Bonding
# cd /etc/sysconfig/network-scripts/

Create a bond file
# vi ifcfg-bond0       

DEVICE=bond0
USERCTL=no
BOOTPROTO=none
ONBOOT=yes
IPADDR=10.0.0.10
NETMASK=255.255.0.0
NETWORK=10.0.0.0
 
TYPE=Unknown
IPV6INIT=no

Edit the Ethernet files.
# vi ifcfg-eth0
DEVICE=eth0
BOOTPROTO=none
ONBOOT=yes
MASTER=bond0
SLAVE=yes
USERCTL=no

# vi ifcfg-eth1
DEVICE=eth1
BOOTPROTO=none
ONBOOT=yes
MASTER=bond0
SLAVE=yes
USERCTL=no

# vi ifcfg-eth2
DEVICE=eth2
BOOTPROTO=none
ONBOOT=yes
MASTER=bond0
SLAVE=yes
USERCTL=no

Due to the fact that /etc/modprobe.conf has been deprecated in RedHat / CentOS 6, the process of bonding network interfaces has changed a bit.

Now instead of defining your bond in your /etc/modprobe.conf, you define it in /etc/modprobe.d/bonding.conf
# vi /etc/modprobe.d/bonding.conf
We’ll be using mode=6 (Balance-alb)

Append the following onto the end out your modprobe config file.
alias bond0 bonding
options bond0 mode=6 miimon=100

Restart the network service
# service network restart

Enjoy :)

Post a Comment

0 Comments